HPE7-A01 Dumps Questions Increase Your Chance of Success

1. A large retail client is looking to generate a rich set of contextual data based on the location information of wireless clients in their stores

Which standard uses Round Trip Time (RTT) and Fine Time Measurements (FTM) to calculate the distance a client is from an AP?

2. The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message is being sent to the AOS-CX switch.

An administrator has performed the following configuration





What is the most likely cause of this issue?

3. Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements. After the configuration was complete, it was noted that a user assigned with the auditors role did not have the appropriate level of access on the switch.

The user was not allowed to perform firmware upgrades and a privilege level of 15 was not assigned to their role .

Which default management role should have been assigned for the user?

4. You are deploying Aruba CX 6300's with the customers requirement to only allow one (1) VoIP phone and one (1) device.

The following local role gets assigned to the phone

port-access rote VoIP device-traffic-class voice

What set of commands best fits this requirement?

5. A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. The legacy devices are connected to Aruba CX 6300 switches throughout the campus.

Which technology minimizes flooding so the legacy application can work efficiently?

6. Your manufacturing client is having installers deploy seventy headless scanners and fifty IP cameras in their warehouse These new devices do not support 802 1X authentication.

How can HPE Aruba reduce the IT administration overhead associated with this deployment while maintaining a secure environment using MPSK?

A. Have the installers generate keys with ClearPass Self Service Registration.

B. Have the MPSK gateway derive the unique pre-shared keys based on the MAC OUI.

C. Use MPSK Local to automatically provide unique pre-shared keys for devices.

D. MPSK Local will allow the cameras to share a key and the scanners to share a different key

7. When setting up an Aruba CX VSX pair, which information does the Inter-Switch Link Protocol configuration use in the configuration created?

8. A new network design is being considered to minimize client latency in a high-density environment. The design needs to do this by eliminating contention overhead by dedicating subcamers to clients.

Which technology is the best match for this use case?

9. A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working to a remote site connected via layer-3 All legacy devices are connected to a dedicated Aruba CX 6200 switch at each site.

What technology on the Aruba CX 6200 could be used to meet this requirement?

10. Which feature supported by SNMPv3 provides an advantage over SNMPv2c?

11. A client is connecting to 802.1X SSID that has been configured in tunnel mode with the default AP-group settings.

After receiving Access-Accept from the RADIUS server, the Aruba Gateway will send Access-Accept to the AP through which tunnel?

12. Y ou need to have different routing-table requirements With Aruba CX 6300 VSF configuration.

Assuming the correct layer-2 VLAN already exists, how would you create a new SVI for a separate routing table?

13. A customer wants to enable wired authentication across all their CX switches One of the requirements is that the switch must be able to authenticate a single computer connected through a VoIP phone.

Which feature should be enabled to support this requirement?

14. You are setting up a customer's 15 headless loT devices that do not support 802.1X..

What should you use?

15. Your manufacturing client is deploying two hundred wireless IP cameras and fifty headless scanners in their warehouse. These new devices do not support 802.1X authentication .

How can HPE Aruba enhance security for these new IP cameras in this environment?

16. A company deployed Dynamic Segmentation with their CX switches and Gateways After performing a security audit on their network, they discovered that the tunnels built between the CX switch and the Aruba Gateway are not encrypted. The company is concerned that bad actors could try to insert spoofed messages on the Gateway to disrupt communications or obtain information about the network.

Which action must the administrator perform to address this situation?

17. Match each PoE power class to Its corresponding 802.3 standard. (Options may he used more than once or not at all)

18. For an Aruba AOS10 AP in mixed mode, which factors can be used to determine the forwarding role assigned to a client? (Select two.)

19. Which statement best describes QoS?

20. A system engineer needs to preconfigure several Aruba CX 6300 switches that will be sent to a remote office An untrained local field technician will do the rollout of the switches and the mounting of several AP-515s and AP-575S. Cables running to theAPs are not labeled.

The VLANs are already preconfigured to VLAN 100 (mgmt), VLAN 200 (clients), and VLAN 300 (guests).

What is the correct configuration to ensure that APs will work properly?

A)





B)





C)

21. Which component is used by the Aruba Network Analytics Engine (NAE)?

22. Your customer has four (4) Aruba 7200 Series Gateways and two (2) 7000 Series Gateways. The customer wants to form a cluster with these Gateways.

What design consideration would prevent you from using all of those Gateways?

23. A customer is concerned about me unprotected traffic between an AOS-CX switch and a gateway, running on AOStO.

What is a feasible option to protect this traffic?

24. Due to a shipping error, five (5) Aruba AP-515S and one (1) Aruba CX 6300 were sent directly to your new branch office You have configured a new group persona for the new branch office devices in Central, but you do not know their MAC addresses or serial numbers The office manager is instructed via text message on their smartphone to onboard all the new hardware into Aruba Central.

What application must the office manager use on their phone to complete this task?

25. With the Aruba CX switch configuration, what is the Active Gateway feature that is used for and is unique to VSX configuration?

26. Refer to Exhibit:





With Access-1, What needs to be identically configured With MSTP to load-balance VLANS?

27. Your customer has an Aruba CX 6200F VSF stack with two switches. A third member (JL726A) needs to be added to the VSF configuration.

What e the configuration that enables the new devices to join the VSF?

A)





B)





C)





D)

28. Your customer has asked you to assign a switch management role for a new user The customer requires the user role to only have Web Ul access to the System > Log page and only have access to the GET method for REST API for the /logs/event resource

Which default AOS-CX user role meets these requirements?

29. What is the order of operations tor Key Management service for a wireless client roaming from AP1 to AP2?

30. Match the topics with the underlying technologies (Options may be used more than once or not at all.)

31. You need to drop excessive broadcast traffic on an ingress port or an ArubaOS-CX switch.

What is the best feature to use for this task?

32. With Aruba CX 6300. how do you configure ip address 10 10 10 1 for the interface in default state for interface 1/1/1?

33. You are deploying a bonded 40 MHz wide channel.

What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?

34. With the Aruba CX 6200 24G switch with uplinks or 1/1/25 and 1/1/26, how do you protect client ports from forming layer-2 loops?

35. A customer just upgraded aggregation layer switches and noticed traffic dropping for 120 seconds after the aggregation layer came online again.

What is the best way to avoid having this traffic dropped given the topology below?

36. A company recently upgraded its campus switching infrastructure with Aruba 6300 CX switches. They have implemented 802.1X authentication on edge ports where laptop and loT devices typically connect. An administrator has noticed that for PoE devices the pons are delivering the maximum wattage instead of what the device actually needs Upon connecting the loT devices, the devices request their specific required wattage through information exchange