Study Online NSE7_SDW-7.0 Exam Dumps to Pass

Category:

Comments:

Post Date:


NSE7_SDW-7.0 dumps questions can help you identify areas where you need to focus your studies. As you answer questions, you will be able to see which topics you are comfortable with and which ones you need to spend more time studying. Fortinet NSE7_SDW-7.0 dumps questions provide realistic practice for the certification exam. NSE7_SDW-7.0 dumps are designed to simulate the actual exam environment, and they will give you a chance to practice answering questions under time pressure. Study free Fortinet NSE7_SDW-7.0 online dumps below.

Page 1 of 3

1. Which two tasks are part of using central VPN management? (Choose two.)

2. Which diagnostic command can you use to show the configured SD-WAN zones and their assigned members?

3. Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)

4. Refer to the exhibit.





In a dual-hub hub-and-spoke SD-WAN deployment, which is a benefit of disabling the anti-replay setting on the hubs?

5. Refer to the exhibits.





Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the receiver.

The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives one reply packet through T_INET_1_0.

Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)

6. Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)

7. Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two.)

8. 1.Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?

9. Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.





What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?

10. Refer to the exhibits.





Which conclusion about the packet debug flow output is correct?


 

TAGS:

Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments

Related

Posts